Does NVIDIA GeForce RTX 4060 (reference spec) work with Corsair RM750e (ATX 3.1, CP-9020295)?
Meets published power requirementsSystem-power recommendation and GPU connectors
Why this works
Yes. Corsair RM750e (ATX 3.1, CP-9020295) is rated at 750 W. NVIDIA gives 550 W as the required system power for NVIDIA GeForce RTX 4060 (reference spec).
- The card needs 1 × 16-pin power connector, and this unit includes a native 12V-2x6 cable rated for 600 W.
Already own both? If your setup meets the requirements below, you can use it without buying a replacement.
Check requirements and buying optionsRequirements and limits
- What you need
- Check your setup
- The power cable that comes with the power supply.
- Power supply
- Check your setup
- 750 W, ATX 3.1
- The card maker's wattage figure is for a whole system built around the card; a high-end processor leaves less headroom.
- This is NVIDIA's specification for the chip. Cards built on it by other makers can use a different power connector and state a different power supply figure; check the exact model.
- Use cables supplied or explicitly approved for this exact PSU. Check the power needs of your complete system separately.
Where to buy
Corsair RM750e (ATX 3.1, CP-9020295)
Before you buy
- The power cable that comes with the power supply.
- 750 W, ATX 3.1
- The card maker's wattage figure is for a whole system built around the card; a high-end processor leaves less headroom.
- This is NVIDIA's specification for the chip. Cards built on it by other makers can use a different power connector and state a different power supply figure; check the exact model.
- Use cables supplied or explicitly approved for this exact PSU. Check the power needs of your complete system separately.
We may earn a commission if you buy through a paid link.
Search Amazon for this model (paid link)
Amazon.com search results. Match the model and revision before buying.
Sources
Comparison of manufacturer specifications
Last checked
Power supply
750 W
Card maker asks for
550 W (required system power)
Card power connector
1 × 16-pin power connector
Setup notes
- Connect the power supply's cable to the card and push it in until it is fully seated.
- Check the case clearance and the motherboard slot separately.
Related pairings
More on Corsair RM750e (ATX 3.1, CP-9020295)
- NVIDIA GeForce RTX 4060 Ti Founders EditionView answer
- NVIDIA GeForce RTX 5070 Founders EditionView answer
- NVIDIA GeForce RTX 5070 Ti (reference spec)View answer
- NVIDIA GeForce RTX 4070 SUPER Founders EditionView answer
More with NVIDIA GeForce RTX 4060 (reference spec)
- Cooler Master MWE Gold 750 V2 Full ModularView answer
- MSI PRO Z690-A DDR4View answer
- NZXT C850 Gold CoreView answer
- ASUS ROG STRIX X870-A GAMING WIFIView answer
Community test reports
No approved reports yet. Queue one and it stays off the page until review.