Does AMD Radeon RX 9070 (reference spec) work with NZXT C1000 Gold (ATX 3.1)?
Meets published power requirementsSystem-power recommendation and GPU connectors
Why this works
Yes. NZXT C1000 Gold (ATX 3.1) is rated at 1000 W. AMD gives 650 W as the minimum PSU recommendation for AMD Radeon RX 9070 (reference spec).
- The card needs 2 × 8-pin power connectors, and this unit has 3 6+2-pin PCIe connectors.
Already own both? If your setup meets the requirements below, you can use it without buying a replacement.
Check requirements and buying optionsRequirements and limits
- What you need
- Check your setup
- The power cable that comes with the power supply.
- Power supply
- Check your setup
- 1000 W, ATX 3.1
- The card maker's wattage figure is for a whole system built around the card; a high-end processor leaves less headroom.
- This is AMD's specification for the chip. Cards built on it by other makers can use a different power connector and state a different power supply figure; check the exact model.
- Use cables supplied or explicitly approved for this exact PSU. Check the power needs of your complete system separately.
Where to buy
NZXT C1000 Gold (ATX 3.1)
Before you buy
- The power cable that comes with the power supply.
- 1000 W, ATX 3.1
- The card maker's wattage figure is for a whole system built around the card; a high-end processor leaves less headroom.
- This is AMD's specification for the chip. Cards built on it by other makers can use a different power connector and state a different power supply figure; check the exact model.
- Use cables supplied or explicitly approved for this exact PSU. Check the power needs of your complete system separately.
We may earn a commission if you buy through a paid link.
Search Amazon for this model (paid link)
Amazon.com search results. Match the model and revision before buying.
Sources
Comparison of manufacturer specifications
Last checked
Power supply
1000 W
Card maker asks for
650 W (minimum PSU recommendation)
Card power connector
2 × 8-pin power connectors
Setup notes
- Connect the power supply's cable to the card and push it in until it is fully seated.
- Check the case clearance and the motherboard slot separately.
Related pairings
More on NZXT C1000 Gold (ATX 3.1)
- ASUS Prime GeForce RTX 5070 12GB GDDR7View answer
- AMD Radeon RX 7800 XT (reference spec)View answer
- NVIDIA GeForce RTX 5060 (reference spec)View answer
- ASUS TUF Gaming GeForce RTX 5070 Ti 16GB GDDR7View answer
More with AMD Radeon RX 9070 (reference spec)
- MSI MAG X870 TOMAHAWK WIFIView answer
- Corsair RM850x (ATX 3.1, CP-9020270)View answer
- NZXT C750 Gold CoreView answer
- Corsair RM1200x SHIFT (CP-9020254)View answer
Community test reports
No approved reports yet. Queue one and it stays off the page until review.