Does BenQ GW2790QT work with System76 Darter Pro (darp11)?
Connect System76 Darter Pro (darp11)'s Thunderbolt 4 port to the BenQ GW2790QT's USB-C port (DisplayPort Alt Mode): one cable carries the picture, charging and USB data.
- The monitor's native mode is 2560×1440 at 75 Hz.
- The monitor supplies up to 65 W to the laptop over the same cable.
Max Output
Up to 2560×1440@75Hz
Required Cable
USB-C DP Alt Mode
Power Delivery
65W
Based on
Manufacturer specs
Setup & gotchas
- Cable
- Full-featured USB-C cable that carries video (DisplayPort Alt Mode) rated for 5 A / 100 W. A charge-only USB-C cable shows no picture.
- OS
- Linux.
- Plug the cable into a Thunderbolt 4 port on System76 Darter Pro (darp11) and into the BenQ GW2790QT's USB-C port (DisplayPort Alt Mode).
- Select the USB-C / Thunderbolt input on the monitor if it does not switch on its own.
- Use the monitor port marked for video/upstream. A data-only USB-C port on the monitor shows no picture.
Sources
Last checked
Where to buy
BenQ GW2790QT
Before you buy
Full-featured USB-C cable that carries video (DisplayPort Alt Mode) rated for 5 A / 100 W. A charge-only USB-C cable shows no picture.
The link opens an Amazon search. Match the listing’s model and revision to the one shown here.
Related pairings
More on System76 Darter Pro (darp11)
- Dell UltraSharp U2723QEPlug & Play
- LG 27UN850-WPlug & Play
- BenQ PD2725U (27-inch 4K Thunderbolt 3)Plug & Play
- ASUS ProArt Display PA279CRVPlug & Play
More with BenQ GW2790QT
- Mac mini (2024, M4)Plug & Play
- Mac Studio (2025, M3 Ultra)Plug & Play
- MacBook Air (M4, 2025)Plug & Play
- MacBook Pro 14-inch (M4, 2024)Partial
Community test reports
No approved reports yet. Queue one and it stays off the page until review.