Skip to content
CompatWiki

Does BenQ PD2706U work with System76 Adder WS (addw5)?

Connect System76 Adder WS (addw5)'s USB-C (DisplayPort Alt Mode) port to the BenQ PD2706U's USB-C port (DisplayPort Alt Mode): one cable carries the picture, charging and USB data.

  • Max Output

    Up to 3840×2160@60Hz

  • Required Cable

    USB-C DP Alt Mode

  • Power Delivery

    90W

  • Based on

    Manufacturer specs

Setup & gotchas

Cable
Full-featured USB-C cable that carries video (DisplayPort Alt Mode) rated for 5 A / 100 W. A charge-only USB-C cable shows no picture.
OS
Linux.
  1. Plug the cable into a USB-C (DisplayPort Alt Mode) port on System76 Adder WS (addw5) and into the BenQ PD2706U's USB-C port (DisplayPort Alt Mode).
  2. Select the USB-C / Thunderbolt input on the monitor if it does not switch on its own.
  • If the picture is stuck at 30 Hz, switch the monitor's USB-C setting to prioritise resolution over USB data speed.
  • Use the monitor port marked for video/upstream. A data-only USB-C port on the monitor shows no picture.

Sources

Last checked

Where to buy

BenQ PD2706U

Before you buy

Full-featured USB-C cable that carries video (DisplayPort Alt Mode) rated for 5 A / 100 W. A charge-only USB-C cable shows no picture.

The link opens an Amazon search. Match the listing’s model and revision to the one shown here.

More on System76 Adder WS (addw5)

More with BenQ PD2706U

Community test reports

No approved reports yet. Queue one and it stays off the page until review.