Skip to content
CompatWiki

Does Dell UltraSharp 27 4K Thunderbolt Hub Monitor (U2725QE) work with System76 Adder WS (addw5)?

Connect System76 Adder WS (addw5)'s USB-C (DisplayPort Alt Mode) port to the Dell UltraSharp 27 4K Thunderbolt Hub Monitor (U2725QE)'s Thunderbolt 4 upstream port: one cable carries the picture, charging and USB data.

  • Max Output

    Up to 3840×2160@120Hz

  • Required Cable

    USB-C DP Alt Mode

  • Power Delivery

    140W (EPR)

  • Based on

    Manufacturer specs

Setup & gotchas

Cable
Full-featured USB-C cable that carries video (DisplayPort Alt Mode) rated for 240 W (EPR). A charge-only USB-C cable shows no picture.
OS
Linux.
  1. Plug the cable into a USB-C (DisplayPort Alt Mode) port on System76 Adder WS (addw5) and into the Dell UltraSharp 27 4K Thunderbolt Hub Monitor (U2725QE)'s Thunderbolt 4 upstream port.
  2. Select the USB-C / Thunderbolt input on the monitor if it does not switch on its own.
  • 3840×2160 at 120 Hz is more than 4K at 60 Hz. Whether you reach it also depends on the laptop's own external-display limit; check System76 Adder WS (addw5)'s display specification.
  • Use the monitor port marked for video/upstream. A data-only USB-C port on the monitor shows no picture.

Sources

Last checked

More on System76 Adder WS (addw5)

More with Dell UltraSharp 27 4K Thunderbolt Hub Monitor (U2725QE)

Community test reports

No approved reports yet. Queue one and it stays off the page until review.